Remotec ZRC-90 - discovered but nothing else

[stephack]

Check this post

Remotec ZRC-90US

ok, just finished the driver for this, so it will be in the next build. There is a trick to pairing it, this is due to the fact that we treat secondary controllers differently than standard zwave devices. If you follow these steps you shouldn't have any issue pairing it. 1- factory reset it, hold the R button until the led turns on then off, follow this with a triple click. 2- open a window with the zwave information page 3- open a separate window and start device discovery 4- click the L …

And this one

Remotec ZRC-90

Update: I got it working. Here is how (and I hate to admit I stooped this low)... I got out my old, decommissioned ST (ugh) Paired the remotec to it (used built in drivers) It did not work until I pressed "Configure" It worked Excluded it from ST Happily powered off ST Paired it with Hubitat using the same procedure as before Happy, Happy, Joy, Joy ... it now works. I am unsure what ST did in the pairing/configure that is different ....