I just realized today from another thread that these even do illuminance with this driver. So I swapped out the drivers for my five sensors with this driver, and I got illuminance values!
Though all my sensors got an initial illuminance value after updating to this driver, that was it. Logs show it never updates after first shot. I can reset the driver and I will again get one initial reading, then nothing after. The value it sends is an accurate illuminance value for that one send, it just doesn't keep sending. I've tested restarting the driver for them with different light levels, and it is getting a true value for light when it does send illuminance that one time. So there is a sensor in there, but it is not reporting based on continued change.
I does seem to wait for an illuminance change before it actually make the attribute first appear after a driver reset, but after that, no level of light change will send an update.
I have three Linptech and two MOES. All acting exactly the same with illuminance not reporting after initial driver install.
