[Project] Device Health Status [Tuya, Aqara, Ikea, Sonoff, Lidl, ThirdReality and others]

[kkossev]

@andrewjunk967

@andrewjunk967

image1668×32

The community driver that should be working with this device (LUMI lumi.remote.b1acn02) is :

https://raw.githubusercontent.com/kkossev/hubitat-Markus-Li-fork/release/drivers/expanded/zigbee-xiaomi-aqara-opple-button-switch-remote-expanded.groovy

Install it manually from the link above, and make sure the Debig logging is enabled.

---

@andrewjunk967

Now I think that most probably the problem is not in the stock driver, but you are experiencing a Zigbee connecttivity problem with your C-8 Pro hub.

Use the following workaround when pairing :

[RELEASE] Tuya Zigbee Contact Sensor++ w/ healthStatus

My "Modified Double Luck Voodoo" process for pairing problematic devices to Hubitat. Please follow ALL of these steps precisely, not skipping and not adding anything else. Bring the problematic Zigbee 3.0 device very close to your Hubitat hub but do NOT power it up (don't plug it in, and remove any batteries). Go to Settings->Zigbee Details and click the "Rebuild Network" button and wait for the process to finish (the "Rebuild Network" button will become enabled again). Click the same "Rebuild…

If after 2-3 pairing attempts (please follow the instructions precisely), the button still does not work, please post the debug logs that follow the start of the pairing process.