Possible bug in trigger for presence and stays?

[rvrolyk]

I had a rule that failed with a trigger that uses the “and stays” functionality. My “stay” was set to 5 minutes and the presence sensor was present for 3 minutes before changing but the rule proceeded after 5 minutes elapsed.

Is it possible there’s a bug in the presence event subscription? Shouldn’t this also subscribe to not present so it can cancel the rule if the device changes?

[brad5]

Take a look at the release notes for .136... looks like it may address your issue.

Release 2.3.2 Available

Release 2.3.2.136 Available Changes from 2.3.2.135 Bug Fixes Fix for enum dropdowns appearing to be populated with nulls. Room Lights: Fixed Restore to prior state before Activation when Turned Off. Fixed table rendering for iOS devices. Fixed import from Motion Lighting for Adjust on Mode Change. Rule 5.1: Fixed Custom Color hue or saturation values of zero. Fixed HSM Custom Rule cancel alert trigger/wait. Fixed bug with presence sensor in Required Expression. Fixed rendering problems w…

[rvrolyk]

Thanks. I should’ve mentioned I tried on .136. @bravenel fixed that bug in required expressions and this seems similar?

[bravenel]

I will look into it...

[bravenel]

This is a similar bug, and it IS a bug.