Possible bug in trigger for presence and stays?

I had a rule that failed with a trigger that uses the “and stays” functionality. My “stay” was set to 5 minutes and the presence sensor was present for 3 minutes before changing but the rule proceeded after 5 minutes elapsed.

Is it possible there’s a bug in the presence event subscription? Shouldn’t this also subscribe to not present so it can cancel the rule if the device changes?

Take a look at the release notes for .136... looks like it may address your issue.

Thanks. I should’ve mentioned I tried on .136. @bravenel fixed that bug in required expressions and this seems similar?

1 Like

I will look into it...

This is a similar bug, and it IS a bug.