No ZWave Device Responding to Action

[jtp10181]

Are you using the supplied stock antennas? Try shutting down and then swapping them, in case the one on the z-wave side is defective.

Also

@jtp10181

Z-Wave Issues

For partial or total loss of Z-Wave control (radio seems dead), before doing anything else please shut down the hub from settings and unplug for 30 seconds, then re-plug to boot back up. This will allow the radios to fully power down and restart. A regular reboot only restarts the platform and not the radio hardware.

Confirm that hub's Z-Wave regional radio frequency matches that of your device. Check hub's region on Z-Wave Details page to ensure that is set to your local region (E.G. EU - 868.4 MHz, 869.85 MHz for European countries).

• How is Hub being powered? Supplied power block or other (explain)
  • PoE power (with splitter) is known to cause major Z-Wave issues on the C-8 hub.
  • See this post for detailed write up on PoE testing: PoE and the C8 (with extensive testing)
• Provide screenshots showing entire Z-Wave details Page
• Provide screenshot of Z-Wave Topology Map (red/blue squares)