I've moved from ST to HE over the last couple weeks, around 100 devices, but have run into a problem with 2 Devices. Both are the Everspring SM103 contact sensor.
This is an old zwave device but has the much sought after external contacts.
It works fine on ST but not on HE. It pairs as a DEVICE in HE and has to be manually set to generic zwave contact sensor. In ST, it uses the generic zwave door/window sensor DTH. It will show battery level but does not recognize open/close status in HE. I did the exclude/reset umpteen times using ST, HE and a Minimote. Tried joining to HE umpteen times. Tried pulling batteries, cycling contacts, etc. All of the things that usually bring sensors to life on both platforms.
I have tried other HE drivers and even tried to import the ST DTH. I changed all of the physicalgraph references and was able to get it to save in HE but the ST DTH didn't work either. I'm lost at modifying the ST DTH any further without direction.
Support says it's most likely a driver issue, because it pairs and can see the battery, and suggested I ask the community.
Anyone ever get this Everspring sensor to work? Anyone have any ideas?
No luck. I excluded rejoined and had to manually set it to your driver. It displayed Battery level and OPEN (just as it does with HE generic driver) but it won't register open/close. I tried both internal & external contacts though I don't think this sensor distinguishes between the 2. Here is the device history:
Ok.. so after debug log is turned on in the device.. go to Logs .. the same place you went to to get the fingerprint .. It should show the values if it is hitting one of the existing methods.. and it will show a skip if it is trying to hit a method that is missing..
It is either a value that it's not expecting for a close event or a different message on close event.. So it should direct me to the correct place in the log..
I know. I'm sorry for being a pain. Nothing is hitting the logs. I understand the event Page now but I just looked at logs, cycled the contact and got nothing. Should I exclude, include, and grab everything I can, including cycling the contact?