Please add a refresh command after "Set Away" similar to what is done for "Resume Program"
Background
On the Ecobee Thermostat page clicking "Resume Program" shows in the thermostat state:
- Resume schedule, followed by
- setpoint is updating, followed by about a 5 second wait, then
- the states are refreshed with the current status and settings
However clicking on "Set Away" shows
- setting away, followed by
- setting thermostat to away. Then
- The physical thermostat sets to away mode, but the Hubitat device does not update until the next refresh interval set in the HE Ecobee app. In my case that is 5 minutes.