try and use the basic Zwave tool DH
you do not have to input anything just select the top 4 get report buttons at the top of the page then look at your logs page.
one of your parameters is different than mine I would be curious to which one.
My DH only reads parameter 8,9,and 11 and pushing config on my DH will only write those 3 parameters to match mine and sets groupingIdentifier 2 and 3 .
and your jumper is off of P5 prior to installing I assume?
Parameter list
I see from your logs your parameter 9 is set to 3 and mine set at 5 but that just tells device to send multivalue sensor updates every (1 = 10 seconds) x seconds.
here are the rest of my parameters:
VersionReport- applicationVersion:1.17
VersionReport- zWaveProtocolVersion:3.42
VersionReport- zWaveLibraryType:Routing Slave
ConfigurationReport- parameterNumber:11, size:1, value:30
ConfigurationReport- parameterNumber:9, size:1, value:5
ConfigurationReport- parameterNumber:8, size:1, value:3
ConfigurationReport- parameterNumber:7, size:1, value:-2
ConfigurationReport- parameterNumber:6, size:1, value:-1
ConfigurationReport- parameterNumber:5, size:1, value:-85
ConfigurationReport- parameterNumber:4, size:1, value:-69
ConfigurationReport- parameterNumber:3, size:1, value:0
ConfigurationReport- parameterNumber:2, size:1, value:0
CommandClassReport- class:0x25, version:1
CommandClassReport- class:0x85, version:1
CommandClassReport- class:0x70, version:1
CommandClassReport- class:0x35, version:1
CommandClassReport- class:0x31, version:1
CommandClassReport- class:0x30, version:1
CommandClassReport- class:0x71, version:1
CommandClassReport- class:0x86, version:1
CommandClassReport- class:0x72, version:1
AssociationReport- groupingIdentifier:5, maxNodesSupported:2, nodes:[]
AssociationReport- groupingIdentifier:4, maxNodesSupported:2, nodes:[]
AssociationReport- groupingIdentifier:3, maxNodesSupported:2, nodes:[1]
AssociationReport- groupingIdentifier:2, maxNodesSupported:2, nodes:[1]
AssociationReport- groupingIdentifier:1, maxNodesSupported:2, nodes:[1]