How does the new Long Range Enrollment work? I have a Zooz LR contact sensor that is already connected. It is on my gate outside.

LR devices connect direct to the hub on a separate frequency - they do not participate in the mesh network.

[image] GuyMan: color of the dot (Repeater or not), ZWLR doesn’t repeat.

[image] hypnosis4u2nv: Maybe it's practical just to see the device in the network map The map is of the mesh network… LR devices are on a separate network and frequency..

[image] bcopeland: ork… LR devices are on a separate network and frequenc OK - Then let's agree to just change the button label from "View Device Graph" to "View Mesh Network" and then eliminate the LR devices from the "Device Topology Grid/Matrix" - As how this is handled today seems very in…

[image] hydro311: Long story short, it'll need to be excluded and re-included as a net-new device. I have used Hubitats "Swap Apps Device" many times to preserve Rules that use a device that is being replaced. But in this case, the old device (800 LR not connected as LR) and the new device (…

If you have another hub (or any Z-Wave controller), you can use it to perform a general exclusion. You could also factory reset the device or add in a third, temporary virtual device between the exclusion and inclusion on the same hub.

[image] dean: Is there a way to Exclude the non-LR device and Include the LR device and still keep the Rule intact? I posted a link to instructions above. [image] [APP] SmartStart Manager for Z-Wave (Long Range support) Custom Apps Official Hubitat Smart…

I have always entered my new ZWave devices manually, and have not used SmartStart. Trying to use Hubitat app SmartStart to add a Zooz ZSE41 800 LR Open/Close Sensor. Using iPhone 15 Pro Max with 3 camera lenses. When I try to use SmartStart to read the Code on the device the app uses my camera, b…

Are you using the beta 2.0 app? That one might fix the camera issues with the newer devices. You can use my app to manually key in the entire DSK if you want. Set the grants to S2 Auth and Boot mode to Long Range. Also, if you have an iPad or any other mobile devices, try on another device and the…

My 14 pro made the QR code very small too but I just kept moving the phone until it became clear. Once it was clear. It picked it right up. Is was small but it worked for my zooz contact sensor.

[image] jtp10181: Are you using the beta 2.0 app? That one might fix the camera issues with the newer devices. You can use my app to manually key in the entire DSK if you want. Set the grants to S2 Auth and Boot mode to Long Range. Not having success, here. Since you cannot side-load apps o…

LR Enrollment

Get Started

jtp10181 May 24, 2024, 11:59pm 25

I posted a link to instructions above.