Just starting off - can't detect 2 switches tz68e -uk

Guys, so my new Hubitat can't detect my 2 switches which work just fine in Vera. I've not tried anything else but this is not a good start.

How do I know if I have been shipped out the correct hub for UK Z-wave frequency. How can I check this?

My switches are z-wave plus devices operating at 868.42Mhz

Any ideas?

Ok I'm stupid... i had believed that the ZWAVE device was internal so I have now plugged in the unmarked usb device (turns out it's Zwave dongle) and I have added a switch...
I my defence, why didnt the software report no zwave controller detected when I tried to pair.. no dont answer that...

2 Likes

This topic was automatically closed 365 days after the last reply. New replies are no longer allowed.