I only manage the devices through the Sharptools app on the hubitat side. I only go the manage connections in Sharptools when something goes wrong.
I did not click the authorize button in Sharptools with no devices showwing/selected as I was afraid to wipe out the connections of devices selected in the Sharptools app in Hubitat? Would you recommend clicking authorize even though no devices are showing?
I do have a C7. It does not have any devices selected in the Sharptools app in Hubitat so I went ahead and selected one device and then proceeded to sync. It shows up fine in dashboards and shows the same thing:
I don't think it is specifically related to the Bond drivers. It just happens that I was adding them to the Sharptools Hubitat app when I noticed this issue. I was adding 1-2 devices in Hubitat, testing them, then adding them to Sharptools, repeat and rinse. This repeated adding in small batches was what highlighted that something was going on. Now, looking at the logs, it may be that it was still completing the sync from the previous addition of devices when I started to add more devices and this caused the dashboards all to switch temporarily to placeholders?
So - bottom line. The connection is working. I think I know what caused the temporary placeholder situation? Still not seeing any devices in the Authorize Sharptools to access your devices but that is not impacting me as I maintain the devices on the Hubitat side.
