Included Neo Z-Wave Plus Smart Mini Plugs - they are recognized, but but have the wrong commands

🎬 Get Started Migrating to Hubitat
1

I've migrated most of my Z-Wave devices successfully from SmartThings to Hubitat. The last two are Neo Z-Wave Plus Smart Mini Plugs. After excluding them and then including them in Hubitat, are recognized, but have the wrong commands - instead of {Configure, On, Off, Poll and Refresh}, like my Aotec devices, I get {Configure, Delete all Child Devices, Delete All Current States, Delete all Current jobs, Delete all States, Get Info and Update Zigbee Firmware (they are actually Z-Wave)}. I've excluded Reset and and re-included them several times with the same result on both.

Any suggestions are appreciated.

2

Go to the button and under "Type" change them to "Generic Z-Wave Plus Outlet" (I think thats the name of it).

Save.

Then press Configure.

Sometimes the automatic driver detection does not work correctly. I suspect it found no driver for your device and set it to the generic "Device" driver.

1 Like
3

Thanks - it was that simple!

4

This topic was automatically closed 365 days after the last reply. New replies are no longer allowed.