@carlosasmartinho As @thebearmay pointed out your devices are incomplete and some had failed the initial pairing creating ghost nodes (the ones with nothing in the routing column). Are these older switches that are non z-wave plus? (This is what I suspect) If so you will need to bring the hub within a few feet of each device in order to pair because unlike z-wave plus, they cannot pair through repeating nodes. Since you have only a few, I would reset the z-wave radio on hubitat and factory reset the devices and start from scratch and move the hub close to each one you pair. This should solidify your mesh. I encourage you to read this as well... Are you new from Wink or Smart Things? This may help!
4 Likes
