Honeywell TCC Total Connect Comfort Drivers

csteele · June 6, 2019, 6:37am

I decided to 'fork' the code in case the existing driver is still working for some.

HubitatCommunity/HoneywellThermo-TCC/blob/master/HoneywellThermo-TCC_C.groovy

/**
 * IMPORT URL: https://raw.githubusercontent.com/HubitatCommunity/HoneywellThermo-TCC/master/HoneywellThermo-TCC.groovy
 *
 *  Total Comfort API
 *   
 *  Based on Code by Eric Thomas, Edited by Bob Jase, and C Steele
 *
 *  Licensed under the Apache License, Version 2.0 (the "License"); you may not use this file except
 *  in compliance with the License. You may obtain a copy of the License at:
 *
 *      http://www.apache.org/licenses/LICENSE-2.0
 *  Unless required by applicable law or agreed to in writing, software distributed under the License is distributed
 *  on an "AS IS" BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the License
 *  for the specific language governing permissions and limitations under the License.
 *
 *
 * csteele: v1.2.2   replaced F/C selection with value from Location in the hub.
 * csteele: v1.2     option of polling interval, off through 60 min. added txtEnable for Description logging.
 * csteele: v1.1.5   allow option of permanent or temporary hold.
 * csteele: v1.1     merged Pull Request from rylatorr: Use permanent hold instead of temporary

This file has been truncated. show original

I would suggest you consider this Alpha Test at best... all I tested was the Dashboard buttons.

I'd like to rework the entire driver and a first goal would be to change to AsyncHttp. The communications with Honeywell is flakey and slow. Probably making this driver a candidate for slowing the hub depending on how rapidly you're polling.