Fingerprint for Aoetec Range Extender 6 (ZW117-A01)

[Eric.C.Miller]

I just installed an Aoetec Range Extender 6 (ZW117-A01). Came up as "Device" so I switched it to the Generic Z-Wave Repeater driver. Here is the data upon pairing:

And I am still on Hubitat Elevation® Platform Version - 2.1.6.118
Hardware Version - Rev C-4
So you may have already corrected this in the newer release.

@mike.maxwell

[mbaran]

I believe this is the default behavior. A few of us have found that this driver

[RELEASE] Iris SmartPlug Z-Wave Repeater (3210-L + others)

Check the health of the Z-Wave repeaters within your Iris Smart Plugs! This driver allows you to keep tabs on whether the Z-Wave portion of the device is working and checks it every 30 minutes. This is a port of my original SmartThings driver. It enables the Z-Wave device within the SmartPlug to communicate status with the hub. Optionally, it can check the health of the repeaters every 30 minutes to make sure they're still online and communicating with the hub. After installing this driver…

Is really helpful because it can regularly check that the repeater is online and... repeating. It does say IRIS repeater, but it works great with my two Aeotec RE6.

[mike.maxwell]

yes, this was added into platform 2.1.7...