Fibaro Z-Wave Plus Motion Sensor ZW5

Author: krlaframboise
Fibaro Motion Sensor - ST DH


  • replace physicalgraph with hubitat


  1. Open in an editor and do a find replace all of physicalgraph to hubitat.
  2. Save the file.
  3. Browse to Hubitat main page
  4. Select Drivers Code
  5. Select New Driver
  6. Paste the new driver code from Step 1
  7. Save
  8. Refresh the device.

I'm sure the directions/info will get better and streamlined as I add more devices.

1 Like

Most functional drivers for z-wave and zigbee can be handled the same way. Remove the Simulator and Tiles definitions (Hubitat has neither of these), and change all instances of “” to “”. Save, and then this will show up in device type (device details page) as a User driver.


Good to know. Now all I need is the code to link ST and Hubitat together while I’m going through migration. I saw Kevin’s stuff I need to check it out.

I can’t seem to get my Fibaro Motion to be detected by the hub. Set defaults and triple tapped button…nada. What was your trick?

What driver are you using? I used krlaframboise driver.

Got it working after resetting a few times. I’m using the same driver.

Glad you got it working. I had to reset my zooz 4-in-1 a couple of times also.

This topic was automatically closed 365 days after the last reply. New replies are no longer allowed.