Cycle Speed on Hampton Bay Fan Controller

[Ryan780]

@cj_rezz

Just to update this thread for others that stumble upon it trying to figure out why the cyclespeed command doesn't work; It seems this is an ongoing issue in Hubitat however @stephack's Advanced Button Controller App works beautifully!

@stephack

Ok, I found the issue by looking at my other methods. I never updated this section to match the others. Replace the entire adjust fan method() with the following:

def adjustFan(device) {
	log.info "Adjusting: $device"
	def currentLevel = device.currentLevel[0]
	if(device.currentSwitch[0] == 'off') device.setLevel(15)
	else if (currentLevel < 34) device.setLevel(50)
  	else if (currentLevel < 67) device.setLevel(90)
	else device.off()
}

Just going by what was linked in the previous post.