Cycle Speed on Hampton Bay Fan Controller

[Ryan780]

@cj_rezz

Just to update this thread for others that stumble upon it trying to figure out why the cyclespeed command doesn't work; It seems this is an ongoing issue in Hubitat however @stephack's Advanced Button Controller App works beautifully!

@stephack

Ok, I found the issue by looking at my other methods. I never updated this section to match the others. Replace the entire adjust fan method() with the following:

def adjustFan(device) {
	log.info "Adjusting: $device"
	def currentLevel = device.currentLevel[0]
	if(device.currentSwitch[0] == 'off') device.setLevel(15)
	else if (currentLevel < 34) device.setLevel(50)
  	else if (currentLevel < 67) device.setLevel(90)
	else device.off()
}

Just going by what was linked in the previous post.

[stephack]

That post was specific to someone that was already using the "adjust fan speed" option for....a zwave fan controller. These devices had their fan speeds adjusted via setLevel commands and needed different commands...precisely why I left the option in the app.

HE may have updated these drivers to work similar to the Hampton...not sure...but I have no plans to remove that section of the app because there is bound to be users who would need it for a ported driver at some point.

The Cycle Fan Speed option was written specifically for the Hampton fans.