Custom driver - Dashboard control

syepes · November 10, 2019, 10:44pm

Hello,

I have just started developing another driver and was wondering is someone could please help me out with the following question.

The driver is for a device that controls the electronic heating by sending the following commands (Stop, Anti Freeze, Eco, Comfort-2, Comfort-1, Comfort)

I can currently change these modes using RM, its nice but not very user friendly.
So I was wondering if its possible to have a "dashboard template" that displays the currently avalable modes and also permits the changing of it.

Just like its possible with the HE internal Modes or HSM:

Below is the actual driver, do I need to add any specific capability or method to make this work?

github.com

syepes/Hubitat/blob/master/Drivers/Qubino/Qubino%20Flush%20Pilot%20Wire.groovy#L26


    capability "Actuator"
    capability "Refresh"
    capability "Sensor"
    capability "Polling"
    capability "Health Check"
    capability "Switch"
    capability "Switch Level"


    command "clearState"
    command "pilotMode", [[name:"mode",type:"ENUM", description:"Pilot mode", constraints: ["Stop","Anti Freeze","Eco","Comfort-2","Comfort-1","Comfort"]]]
    attribute "mode", "enum", ["Stop","Anti Freeze","Eco","Comfort-2","Comfort-1","Comfort"]


    fingerprint mfr: "0159", prod: "0004", model: "0001", deviceJoinName: "Qubino Flush Pilot Wire" // ZMNHJA2
    fingerprint mfr: "0159", prod: "0004", model: "0051", deviceJoinName: "Qubino Flush Pilot Wire" // ZMNHJD1 (868,4 MHz - EU)
  }


  preferences {
    input name: "logLevel", type: "enum", title: "Log Level", options:[[0:"Off"],[1:"Info"],[2:"Debug"],[3:"Trace"]], defaultValue: 0
  }
}

syepes · November 11, 2019, 8:33pm

Looks like I am not the only one looking for this

Ryan780 · November 11, 2019, 11:12pm

Yup...can't do it currently.