This worked, I'm updating the instructions so there is a complete set
- Install the super basic zwave tool note here
- Install it under "Device Code" in the advanced section (lower left) of the portal navigation. (Not app code.)
- Change my device driver for the motion detector to the zwave tool
- In your device, select the Zwave tool from the Type dropdown
- Wake up your device if it is battery powered. (See your instruction manual.)
- See the value of the parameter: Get Parameter Report (number = parameter number)
- See the Logs (past logs) to see the results
- Set the parameter: eg: 3, 1, 4
- Confirm the parameter has changed (Get Parameter Report)
- Change the device driver back
- Optional - confirm that "configure" will not reset the parameter
- Wake the device up again if necessary
- Push the configure button (in the normal device driver)
- Reload the Zwave tool and do a parameter report. See if it has reset.
- if not, you're good.
- If so, reset it, and then never push the configure button on the normal device driver
- Reload the normal device driver
