Hi. I bought a few SNZB-04 contact sensors after researching here in the forum, but I end up getting frustrated with it... I managed to pair it and have it working with the driver created by markus here . However, I see that the devices never send any check-in or regular reporting. The consequence …

I have a couple of these and I'm not having any issues using Markus's driver. That being said, there is a system driver for this device. Have you tried that one? It may work better, I don't know. EDIT: As an aside, which version of the driver are you using? Mine is * driver : v1.0.1.1123

[image] Newbie help diagnosing sensor dropping off network Devices SONOFF SNZB-04 is one of the most difficult to troubleshoot Zigbee devices. It operates in a 'deep sleep' mode all the time, the only exception is when it is paired to the hub, when the contact state chang…

I have a WC Piston that checks the presence of these devices every 3 hours. I see these go 'not present' and back 'present' again quite regularly. They do always come back though.

Hi, Sorry for the late reply. After creating this thread I paired up again the device and I am monitoring to see if it will fall off again. So far it has been good! I noticed in the device's event list a number of "not present counter" while the window hasn't been open/closed but once I open/close …

No! Tks for pointing out. Do you think it is okay if I just install this driver and switch the current device to use it? Or should I remove + unpair the device and do everything from scratch to use this Tuya driver?

Install the driver, manually assign it to your device, then obligatory pair the sensor again (without removing the device). Most of the Sonoff battery-powered sensors will accept the reporting configuration commands only for a limited time period after the pairing.

Can I set a check-in frequency for sonoff snzb-04 zigbee contact sensors?

Get Help Devices

kkossev August 4, 2024, 4:01pm 3