C7 S2 Fails?

[krlaframboise]

@mike.maxwell

This isn't anything we can change, the z-wave stack we are required to use with the 700 series chip doesn't allow this.

@krlaframboise

Just to clarify, it's possible to disable S2 and S0 for S2 devices, but it's not possible to disable S0 for non-S2 devices?

@mike.maxwell

Correct, unless it's a barrier device anyway.

@bill.d

You can pair them unsecured via a USB secondary controller and PC Controller software.

Apparently non S2 devices that support S0 work fine when joined without S0 so what you said about not supporting that isn't a limitation of the hub's z-wave stack, unless that's just the inclusion piece of it, but was it a requirement for z-wave certification?