My C7 Hardware
- Hubitat Elevation® Platform Version: 2.2.4.158
- Hardware Version Rev C-7
- Z-Wave Radio Devices: 0
- Z-Wave Updater: Firmware is already up to date
I have a wide variety of the Zooz Z-Wave devices listed below. Most Zooz devices never complete the inclusion/initialization phase from a factory reset Zooz device. Randomly, one might complete the inclusion initializing phase with S2 no authentication or No security inclusion, but eventually the device looses all Z-Wave network connectivity over 1-2 hours, whether I invoke 'Repair Z-Wave Network' or not.
I have reset the C7 Z-Wave radio and started from a freshly powered off, removed power cable on the C7 for 30 seconds, and restarted the Z-Wave inclusion again. Same symptom stuck at inclusion/initializing screen below. All Zooz devices successfully complete inclusion on the older C5 hub! All Zigbee devices work perfectly on the same C7 hub, so Z-Wave to Zooz is very problematic and corrupts the other Z-Wave devices being that they loose their Z-Wave connectivity and a repair network ghosts the unreachable Zooz devices...
My Zooz devices
- Zooz Z-Wave Plus S2 On Off Wall Switch ZEN26 with NEW Simple Direct 3-Way and 4-Way (Works with Existing On Off Switches, No Add-Ons)
- Zooz Z-Wave Plus On Off Wall Switch ZEN21 (White) VER. 3.0, Works with Existing Regular 3-Way Switch
ZOOZ - ZOOZ Z-Wave Plus 4-in-1 Sensor ZSE40 VER. 2.0 (motion / light / temperature / humidity)
ZOOZ - Zooz Z-Wave Plus S2 MultiRelay ZEN16 for Garage Doors, Sprinklers, Gas Fireplace; 3 Dry Contact Relays (15A, 15A, 20A); 12-24 V AC/DC or USB C Power
- ZOOZ Z-Wave Plus 4-in-1 Sensor ZSE40 VER. 2.0 (motion / light / temperature / humidity)
ZOOZ - Zooz Z-Wave Plus S2 Wall Dimmer Switch ZEN27 VER. 2.0 with NEW Simple Direct 3-Way and 4-Way (Works with Existing On Off Switches, No Add-Ons) and No-
ZOOZ
