https://community.hubitat.com/t/release-ge-z-wave-plus-motion-switch-component-driver/48951. Ranchitat...Perhaps this a motion detector that could solve a problem I've been having since 2004, believe it or not. I have a L-shaped garage with a shop that requires two motion detectors to fully span where I might be when I'm working in the shop. Every detector I've tried has a timer that issues a "no motion detected" command at the end of a set duration with no motion. And it only issues a "motion detected" signal if the timer is not running. Perhaps I could write a custom program with three boolean variables, one for each sensor that is true if it's timing for an off command (otherwise false), and the third that's true if the lights are on. If the lights are off and either sensor went to true, I would turn the lights on. If the lights are on and both sensors indicate no motion then the lights would turn off. Do you think the GE sensor would support that? Note that I just got my Hubitat yesterday and have never written a program, so I have a long road ahead on this, but I'm willing to try...
Download the Hubitat app
