I can't figure this out. I have two z-wave devices that show up every time i do an inclusion but they stay at initializing.
Problem is, I have no idea what they are! Everything i can think of is accounted for, and I dont understand why they would even show up unless I pressed an inclusion button on a device.
I'm guessing the IDs stay the same? If so shutdown from settings then pulling the power once it has shut down and leave it unplugged for a few minutes before returning power should correct it at least it did for me a while back.
I'm guessing the IDs stay the same? If so shutdown from settings then pulling the power once it has shut down and leave it unplugged for a few minutes before returning power should correct it at least it did for me a while back.