Hi All,
I have been doing some renovations over the last year and not used my Hubitat C7 in all that time. From memory when I discovered the devices there was 3 device entries, 1 the main device and when turned on / off it controlled both outputs at the same time, 2&3 where the different channels and on/off just triggered the relevant channel.
Now the main device remains but none of the single channels are available. Guess I'm going to have to do a exclude and include of each one of the devices again but this is a pain.
Also all my rules ave disappeared I have found one broken rule.
The zwave issue was there before I did both a platform and zwave firmware updates.
Not sure about the rules as I didn't check that part of the system before doing the updates. Guess I'm going to have to rewrite the rules again a pain.
Any thoughts would be much appreciated.
Thanks
