So i apologize ahead of time, because I'm sure with enough searching the answer is probably out there, but I didn't seem to find a solution upon some quick looking around. Trying to use the Zooz ZEN27 button 7 (up paddle 4 times) to activate other things via the rule machine, but looks like that bu…

Looking a little deeper into this; scene control isn't on by default (Parameter 13), however per the attached, looks it actually in enabled in the switch? now i'm really confused. [Capture]

Check this out.. It may help you.. [image] [RELEASE] Advanced Zooz Zen27 / Zen26 Central Scene Dimmer and Switch Drivers Custom Apps and Drivers Advanced Zooz Zen27 / Zen26 Central Scene Dimmer and Switch Drivers [ZenCapture] All device configuration va…

sucks you have to be on 2.8... updating firmware on these switches isn't trivial. I mean, it is, but it's just a pain and require extra hardware.

[image] dyshuk: but it's just a pain and require extra hardware. Nope.. it's super easy now.. With no extra hardware [image] [RELEASE] Z-Wave Firmware Updater Custom Apps and Drivers Hubitat OTA Z-Wave Firmware Updater [584828d8cef1014c0b5e49ee] …

[image] dyshuk: e that button push is not being recognized (nothing shows up on the logs). Hubitat tells me i'm on firmware 2.7 (i'm guess that means 2.07 based on Zooz's website) I have used @bcopeland 's firmware tool. Works really well on the Zooz switches

Updated 3 zooz switches today using the tool. Worked but I had to exclude / re-include for them to work again. Curious if that happened to you too?

That has happened on all my Zooz so far. I think I have updated 4 various switches at this point? I have a few to go, but have been spreading the "fun" of excluding and including and fixing all the automations for a few days. Still very happy we can do this firmware flashing though.

yea happened on all my Zooz switches too. But I only have 2 with rules attached so not too big a deal.

What is the correct combination of settings to get instant on/off for both physical and z-wave controls? Currently it feels like my z-wave commands are instant, but the physical controls go through a dimming or delay period.

You'll need to set the physical ramp rate setting to 0 (instant on/off).

Zooz ZEN27 Extra Buttons

Get Help

bcopeland April 28, 2020, 2:44pm 5

Nope.. it's super easy now.. With no extra hardware