At long last i finally had an electrician out to swap out about 6 dumb switches with Zooz 73 and 74 switches and dimmers.
One of the Zen 73’s controls my outside garage lights which have Inovelli RGB bulbs in them. Is there any special way i need to configure the switch to work with them?
Smart bulb mode isn't enabled by default in Zooz switches, so you'd have to enable that at least.
ZEN73 On/Off Toggle Switch Advanced Settings - Zooz Support Center (getzooz.com)
Thinking about it more, Jeff's "Zooz ZEN Switch Advanced" driver (available in HPM) probably covers 73/74 too (not 100% sure since I don't have any myself) -- that would definitely be the best driver to use, and it would likely surface all the parameters to edit right from the device page.
I also recommend Jeffs driver. I have several Zooz 73 switches and all the parameters can be changed in the driver.
On top of disabling physical control, you'll want to enable scene control. That will allow you to use the toggle as a button device.
This topic was automatically closed 365 days after the last reply. New replies are no longer allowed.
Download the Hubitat app
