Hi there,
I just picked up a Zen17 and I've been encountering a strange issue. Everything is configured properly and generally working, but fairly frequently I am experiencing an issue where the garage door app receives an open or close command, but it doesn't actually engage the associated relay. So its not a zwave issue; I don't think it's a hardware issue... and I haven't seen anyone else report this issue, so it's hard to believe its a driver or app issue...
Take a look at these logs (bolded the relevant part). You can see the device receives the command, but the app doesn't engage the relay despite it going through the process of thinking its closing.
dev:2492022-10-08 02:38:24.496 PM debug Garage Door - door is closed
app:2272022-10-08 02:38:24.487 PM debug Contact sensor changed to closed
app:2272022-10-08 02:38:13.657 PM debug Relay Switch Turned on
app:2272022-10-08 02:38:13.278 PM debug Turning on Relay Switch...
dev:2492022-10-08 02:38:13.202 PM debug Garage Door - door is closing
dev:2492022-10-08 02:38:13.187 PM debug close()...
app:2272022-10-08 02:38:10.183 PM debug Sending Notification: Garage Door Failed to Close
dev:2492022-10-08 02:38:10.169 PM debug Garage Door - door is open
dev:2492022-10-08 02:37:57.124 PM debug Garage Door - door is closing
dev:2492022-10-08 02:37:57.109 PM debug close()...
dev:2492022-10-08 02:37:51.377 PM debug Garage Door - door is open
app:2272022-10-08 02:37:43.092 PM debug Contact sensor changed to open
app:2272022-10-08 02:37:38.333 PM debug Relay Switch Turned on
app:2272022-10-08 02:37:37.925 PM debug Turning on Relay Switch...
dev:2492022-10-08 02:37:37.812 PM debug Garage Door - door is opening
dev:2492022-10-08 02:37:37.794 PM debug open()...
dev:2492022-10-08 02:35:39.943 PM debug Garage Door - door is closed
Any thoughts? I am at a loss how to make this work consistently. Thanks!