Z-Wave stats blank after upgrade

🛎️ Get Help
1

Maybe this is normal and they will repopulate, but after upgrading to the latest release I noticed under my Z-wave stats they were cleared. I was looking into any issue with my garage door status not updating after doing the hub update. It seemed my tilt sensor stopped reporting for my garage door.

I ended up doing a Z-Wave repair and sensor is reporting again, but my device stats are still empty.

I went from...
2.3.1.142 > 2.3.2.131

2

Yes, it gets cleared on a reboot and will populate over time as the devices communicate.

3

I went through the same thing. All I did was reboot, though they said it wasn't required. It was fixed. Zigbee section was just fine.

4

Thanks, my RTT Avg has populated back on all 27 of my devices, but only 4/27 of my LWR RSSI has populated so far after 4 hours.

5

Shut down the hub and unplug (at the wall not the hub) for 5 mins, power back up and you'll be fine.

1 Like