Struggling with how code executes

[jshimota]

I gave that a try, while I got no error when I saved the driver it didn't change the log results.

I found this:

Question about refreshing devices state automatically

Is it possible to configure Hubitat to automatically update the devices state after sending commands to them? I haven't found any configuration to do that, maybe it's doable via custom app. Why Hubitat does not update the device state automatically? Example, when interacting with an outlet, if we send the command "on", the real device goes to the "on" state but Hubitat continues to hold its old state "off".

In the end, I did away altogether with sending that to the log - I think it's bugged - I tried making it a bool and tried a few other tricks but I'm dropping it!