Spruce Zigbee Soil Moisture Sensors - driver needed?

dan.t · July 8, 2019, 3:43pm

I migrated the public ST driver to use the HE nomenclature, there are some raw zigbee commands in there that had to be changed from "st.... " to "he....."

You can find that driver here:

github.com

danTapps/Hubitat/blob/master/Drivers/Spruce Sensor/Spruce Sensor.groovy

/**
 *  Spruce Sensor -updated with SLP3 model number 3/2019
 *
 *  Copyright 2014 Plaid Systems
 *
 *  Licensed under the Apache License, Version 2.0 (the "License"); you may not use this file except
 *  in compliance with the License. You may obtain a copy of the License at:
 *
 *      http://www.apache.org/licenses/LICENSE-2.0
 *
 *  Unless required by applicable law or agreed to in writing, software distributed under the License is distributed
 *  on an "AS IS" BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the License
 *  for the specific language governing permissions and limitations under the License.
 *
 -------10/20/2015 Updates--------
 -Fix/add battery reporting interval to update
 -remove polling and/or refresh
 
 -------5/2017 Updates--------
 -Add fingerprints for SLP

This file has been truncated. show original

I have to say, I am not overly impressed with the device. The temperature is always the same as the environment and the humidity readings don't seem to be to accurate, as in: Put in in a glass full of water and get 68% humidity.....