[SOLVED] Community Rocks!

[baldog]

I've done two posts about it. I think its a bug more than anything though

Semi complicated if this then that rule

That's definitely pink, but it's also off. Did "Current States" report "switch: off" at the time of capture? If done in your rule, you should be turning the bulb on before capture and so it should be on, but I guess it wouldn't hurt to insert a small delay--or a large one when for the purposes of testing so you have time to check the state before the rule captures and then changes it to red--just to be sure it doesn't say this.

Lights go red on contact change

If that first screenshot was indeed created after only manipulating the bulb using the Hubitat device page, I'm not sure how you got there. The bulb is reporting that it's a slightly unsaturated, white-ish green or yellow, not white. To set a Hue bulb accurately to a shade of white, use Set Color Temperature and put in your desired value. I'd suggest around 2700 to 3000 (units are Kelvin, but don't type that) for a warm white. You should see "colorMode: CT" instead of "colorMode: RGB" after that…