No, there have been other similar cases but I never connected the dots to think about the association being blown up.
You can just try configure on other drivers as well to see if it fixes it, some do the lifeline association and some do not.
You can also use this driver/tool: [RELEASE] Z-Wave Universal Device Scanner . You just switch to that driver temporarily and it has a special command button to set the association. You do not need to run any of the other commands there (but they wont hurt anything either if you want to try it out).
When you switch back to your regular driver just run configure again on the normal driver.
If you have any battery devices impacted you would need to wake the device manually then press the command button ~2-3 seconds later.
