Another thing I noticed is the firmware for the motion sensor I have on SmartThings updated from 0x00000011 to 0x00000014
Is there a way to check the firmware revision on the Hubitat platform?
Is the procedure to remove the device from Hubitat and and pair on SmartThings then move it back when the update has been installed?
Not that I’m aware
These seem to repeat for about 10 devices each. I have around 65 zigbee end devices on my one HE with 4 outlets and 4 GE in-wall zigbee dimmers as the only repeaters and it is very stable. You might just replace a few of the centralites with these.
Thanks for the tip. Right now I am temporarily moving each motion sensor over to SmartThings and allowing the firmware to update and then move them back. It would be nice if the firmware corrects the dizmal battery life but I'm not holding my breath. Overall my zigbee devices are doing great with no dropouts in over 10 months. Once I got rid of the cree and GE bulbs and replaced with Sengleds.
1 Like
That’s good news.
2 Likes
This topic was automatically closed 365 days after the last reply. New replies are no longer allowed.
