I've been experiencing a decline in the performance of some of my wave devices recently. I attempted to remedy the situation by conducting a repair since I've moved several devices lately. However, the repair was unsuccessful for more than 90% of nodes. I'm sharing the logs, zwave specifics, and a screenshot of the report below. I would greatly appreciate any help or suggestions from the community on how to address this issue.
0x03 & 0x34 too, right? (Asking because if you don't think it's a ghost, I'd be interested why)
ah, I see now, you told him about the ones that say 'Discover,' not just the ones without routes. I think the above 2 that I mentioned are possible ghosts, but the 4 @aaiyar mentioned are definite ghosts.
I was able to remove 3 using device specific repair and then remove, but 0x26 has no repair option (see screenshot). For this last pending one, is there simpler method than using something like this: Removing ghost devices ?
You dont use repair to get the remove button, you use refresh. Click it once and wait for page to reload.
Looks like 0x10 is also a ghost node (not attached a device entry at all).
Looks like your screenshot was done right after a reboot, would like to see another one with at least 12 hours of uptime. Also, do you have any power reporting devices? They will cause issues if the reporting is configured poorly causing lots of traffic.
Nothing jumps out as being horrible. A lot of those shade controllers have a lot of route changes which is a little concerning (could be leading to your issues, or an effect of other issues).
So I see 0x33 recirculating pump, sounds like maybe that is a plug, ZEN15 possibly?
And then also 0x40 Is the ZEN25.
For the ZEN25 it is known to cause issues when the reporting is left at defaults. If you are not using the info I would set all the reporting intervals / thresholds very high to get minimal reports. There is also a newer parameter you can set to totally shut off the reporting but it is not visible with the system driver. Parameter 18: https://www.support.getzooz.com/kb/article/1154-zen25-double-plug-advanced-settings/
@yashvind Can you help me update my Bali Autoview firmware? I tried to message zebra blinds but the support email bounced back and it looks like the website doesn't exist anymore. Also I'm a new member here so I couldn't message you directly.
Probably not. Honestly I looked at those at one point and thought they were too expensive. I ended up going to blinds.com and getting my blinds then using an AM43 to control them. For my lattice blinds I use an iblinds v3 on each one.
