I'm looking for information on integrating the Ring Siren directly to Hubitat. I know there have been posts on this already but they all seem to be closed so I'm starting a new one. I want to use it as a stand alone Z-wave outdoor siren. I've connected it to HE and can turn the siren on and off but am unable to turn on the Ring Logo or the red strobe which would typically activate along side the siren. After some reading online I've managed to find the below commands which turn the Logo & Strobe on and off. Unfortunately I'm not sure if or how any of this can be implemented through Hubitat. Any advice would be appreciated.
Ring LOGO LED
command class: 135
property: 48
property key: 1
value: 0-100
Red Strobe LED
command class: 135
property: 13
property key: 1
value: 0-100
