Tasmota firmware has a lot of issues...
doesn't work correctly
Doesn't work button on/off in dashboard.. Only off function
You shouldn't have the device as a button controller in the dashboard. it is a switch. That's why the button template won't work correctly. Look at the driver that you have. It doesn't even have the button capability.
I meant switch or outlet...not a button
You have to use Eric's custom firmware based on Tasmota, like I said. That problem doesn't exist.
I do using
No, I asked you what firmware you were using and you showed the one on this thread. I'm talking about this firmware.
Yes. I told you about this firmware too. That it doesn't work into dashboard as on function only OFF
That's because the driver doesn't match the firmware. You can't use the driver from one post with the firmware from the other.
1 Like
I don't suppose anyone else here has had any success with the Sonoff RF Bridge in HE? @ericm has not yet responded to me on my issue but I did wonder if others have one and have tried it with the same result as me?
Hello.
This is very helpful thank you. Do you know if any of these will work with the Sonoff Mini? I'm looking at getting some.
Thanks
Martyn
1 Like
If you want use additional momentary button or switch (s1 and s2) which is gpio 4 so answer No.. Need use tasmota only( in tasmota add action on gpio4)
If don't need additional button yes you can use this connect firmware
1 Like
I’m not sure I understand I’m afraid. My hope is to install these behind a single light fitting and keep the light switches (some 1 way some 2 way) working as normal. Thanks
Use tasmota firmware:
1 Like
But if say truth... In my case. I have original firmware from tasmota "sonoff-basic.bin"
Bc if you will flash it from new sonoff DIY mode. It has limitation of space and ericm firmware over sized..(larger than the size allowed)
With this driver:
And after .. in tasmota you need go to configure module and change gpio4 to switch1 if you want use regular wall switch...
1 Like
hello, I've loaded the basic firmware, the driver and the connect app but my sonoff doesn't get detected. it can be detected off of the 3v supply correct? any pointers are appreciated!
I"m running into a problem with this app where it'll take DAYS for the hub to scrape new IP's of the sonoffs I have in my environment. For example, I rebooted my router yesterday to assign a couple dhcp reservations for some non-smarthome stuff and when it came back up some of the sonoffs had different IP's. Its been over 24hrs and the sonoff's still show their old IP's... Is there any way to manually scrape them?
I actually have't seen that issue. They should send out an SSDP "probe" every 5 minutes that the Sonoff Connect app should parse and change the IP address. Can you watch the logs for any info coming in?
Any suggestions of the basic isn't detected or should I give up on this?
can you access the web interface of the device via the ip address?
I'm good now! Thank you!
1 Like
