"Refresh" On Z-Wave Details Page Doesn't Do Anything

🛎️ Get Help
1

Has anyone else noticed that the "Refresh" button on the Z-Wave Details page doesn't do anything?

I was going through the list "tuning up" the slower routes by repairing them. (Not sure this does anything, actually, but what the heck.)

Hitting "Refresh" doesn't do anything. I have to go to the Device page, hit "Refresh" there, and then go back to the Z-Wave Details page and hit "Refresh" there. Usually goes to direct route to hub with 100 kbps. Again, not sure this is meaningful.

I wonder if someone at support, @bobbyD ? could look at this? Maybe just a small change required.

2

You can always confirm if it does anything by looking at the logs while you pressing the refresh button.

3

Confirmed.
Does nothing.
Refresh on Device page does, oddly enough, a refresh. :slight_smile:

1 Like
4

It just would make it that much more convenient.
Stay on one page, do a repair and refresh and see the results!