Qubino 1D Relay Module

darren.rockach · December 14, 2020, 7:22pm

The auto off function for this driver does not work.
My settings are as the image shows. Am I doing something wrong or is there a bug with the driver?

ritchierich · December 15, 2020, 2:09am

I have 2 of these paired to a C-4, 1 of them for over 2 years. The auto off works great.

You could try @ericm’s driver he wrote for ST and ported over to HE a few years ago. I was using it before @mike.maxwell created a stock driver.

github.com

erocm123/Hubitat/blob/master/Drivers/qubino-flush-1d-relay.src/qubino-flush-1d-relay.groovy

/**
 *
 *  Qubino Flush 1D Relay
 *
 *  github: Eric Maycock (erocm123)
 *  Date: 2017-02-20
 *  Copyright Eric Maycock
 *
 *  Includes all configuration parameters and ease of advanced configuration.
 *
 *  Licensed under the Apache License, Version 2.0 (the "License"); you may not use this file except
 *  in compliance with the License. You may obtain a copy of the License at:
 *
 *      http://www.apache.org/licenses/LICENSE-2.0
 *
 *  Unless required by applicable law or agreed to in writing, software distributed under the License is distributed
 *  on an "AS IS" BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the License
 *  for the specific language governing permissions and limitations under the License.
 *
 */

This file has been truncated. show original

darren.rockach · December 15, 2020, 9:55am

Thanks for confirmation that it does work. I have delved a little deeper and it seems it does auto turn off but not until a manual (or via automation script) refresh is done. Anyone any idea why?

Thanks

system · September 22, 2022, 5:18pm

This topic was automatically closed 365 days after the last reply. New replies are no longer allowed.