New Konnected Pro setup to existing alarm, devices not showing

[Alf]

Hi guys,

I'm looking for help from anyone who has successfully installed a Konnected system to their existing alarm system.

I've just wired a Konnected Alarm Panel Pro and one Interface board, to my existing 6 zone system. The existing system has motion sensors and a door sensor.

I installed apps and drivers as per this and this.

I see this in my apps and drivers area of the hubitat:

In my devices though, I only have a single one of the motion sensor zones listed after naming all five, and the door contact sensor isn't shown either.

I'm getting the following errors in my logs:
2021-03-28 10:35:40.918 am [error](http://hubitat's.ip.ip.ip/installedapp/configure/151)org.codehaus.groovy.runtime.InvokerInvocationException: com.hubitat.app.exception.UnknownDeviceTypeException: Device type 'Konnected Contact Sensor' in namespace 'konnected-io' not found (updated) 2021-03-28 09:20:45.990 am [error](http://hubitat's.ip.ip.ip/installedapp/configure/151)com.hubitat.app.exception.UnknownDeviceTypeException: Device type 'Konnected Contact Sensor' in namespace 'konnected-io' not found on line 321 (updated)

Any hints as to what to try next?

[ogiewon]

Tagging @nate from Konnected

[BorrisTheCat]

You enable oauth for konnected pro when it should have been just device.

[BorrisTheCat]

You haven't installed the contact sensor as well that's your main issue.

[Alf]

Cheers you nailed it!

I had installed the switch driver thinking that would handle the door sensor, and didn't spot that there was a contact sensor driver.

Once I installed the contact sensor, all of the motion sensors and the door sensor showed up and all work perfectly. I just had to tweak the trim pot on the interface board for one of the sensors as it wasn't picking up the change of state when the motion sensor triggered.