MCO Home Floor Heat Thermostat

🛎️ Get Help
,
1

I have three MCOHome-brand MH4 line level thermostats that I use to operate my floor heat systems. They add to Hubitat as a non-specific device. If I recategorize them as General Z-Wave Thermostat I can operate them (set heating set point, etc.), but they have extra buttons for fan mode, etc., that a simple floor heat thermostat doesn't support. Is there a better device driver I should be categorizing these devices with?

  • deviceId: 20737
  • deviceType: 1025
  • inClusters: 0x5E,0x86,0x72,0x5A,0x85,0x59,0x73,0x20,0x7A,0x70,0x31,0x43,0x40,0x42,0x8A,0x8B
  • manufacturer: 351
  • zwNodeInfo: D3 9C 00 04 08 01 5E 86 72 5A 85 5C 59 73 20 7A 70 31 43 40 42 8A 8B 68 23
2

After you click save did you click configure?

1 Like
3

I had not. (I'm new to Hubitat!) When I click configure I get:

  • supportedThermostatModes : ["off","heat","energy save heat"]
4

Yeah the generic z-wave driver exposes all modes and attributes that that specific thermostat broadcasts. So everything that is available from it through z-wave is now on the device page. It's up to you to use whichever ones you need to use :slight_smile: Also you probably want to use generic z-wave plus thermostat. :slight_smile:

1 Like
5

This topic was automatically closed 365 days after the last reply. New replies are no longer allowed.