It was reporting fine and then just stopped. It's set to report at 1W increments. I've hit refresh and configure, nothing changes. Any ideas why it stopped or how to get it going again?
It's using the Generic Zigbee Outlet driver.
Clicking on or off under Commands changes the outlet, however the status is not updating in Current States or the Events.
It could be broken...
It's definitely broken...
Without any action on my part power is once again being reported.
What driver are people using for this device? the Generic Zigbee outlet doesn't report power.
With the generic driver you have to Enable automatic power reporting under Preferences.
Same thing on this thread. See Mike Maxwell's response just below this linked post.
Download the Hubitat app
