I went into the web interface today to shut down my C-4 hub after upgrading the firmware to the latest release. I actually forgot about it for about 30 minutes, went down (it's in the basement) and it had the "red" status LED on. I unplugged it for 30 seconds, plugged it back in and got a single "red" flash. No "blue" booting LED or "green" LED when it was up and running. I confirmed the system is running fine otherwise even though there is no LED lit on the device. I've performed a controlled shutdown and power up 3 times now and get the same weird no blue or green LED status. By looking at it, you would think it's dead. Signed, Puzzled...
I believe this has been reported before with the C5 hub by some users.
Perhaps @bobbyD could elaborate.
The important thing is that it is working OK.
I agree it would be nice to see the hubs led to determine the hubs state.
I agree Bob, it's just one of those things you say to yourself, "I know I used to see an LED on that thing"... The saving grace is that the hub is in the basement. That lets me bring the radio stick up on an extension so it blends in with the room better. Probably the number one reason upgrading isn't on my mind (I prefer the external radios). -Joel
