Halo RL56 reset for migration

🎬 Get Started Migrating to Hubitat
1

I am starting a migration from SmartThings V3 to Hubitat C7. No huge surprises, so far, adding a couple of new devices and moving 5 devices. My first significant roadblock is trying to reset a Halo RL56.
[Link to the exact item purchased on Amazon, for reference]
[Link to wireless guide, indicating 6x on/off to reset]

Maybe I am being pedantic, but switching on/off would leave the device un-powered. So, my confidence in the instructions is already shot. I tried off/on cycles instead - every combination between 2x and 8x - with no luck.

Anyone with experience resetting these? Shot-in-the-dark ideas?

2

Perhaps I was over-thinking this, since it was my only Zigbee device that would not perform a proper reset. Deleting from ST was all that was really needed and it is now added as Generic Zigbee CT Bulb.

3

Hi I'm also interested in the Halo Home RL56. Were you able t directly connect them to the Hubitat C7 without any additional hubs?

4

Yes, this is connected to C7 and behaving as expected. All of my devices are now exclusively on Hubitat.

[Welcome to the forum!]