GE Switch oddity

I have a GE Z-Wave paddle switch in my kitchen. For some reason, Hubitat does not recognize manual turn on/off. If I refresh the device, it seems to "catch up". Control of the light in the app, and in RM, seems to work fine. The driver sees this as:

  • deviceType: 18770
  • inClusters: 0x25,0x27,0x73,0x70,0x86,0x72,0x77
  • deviceId: 12338
  • manufacturer: 99

I have an identical switch in another location that works as it should. Manual control updates in Hubitat instantly. For some reason, the kitchen switch is not refreshing the device driver.

The switch worked fine in ST. Both switches are defined as "Generic Z-Wave Switch"

Any suggestions?

Known issue. See below

Thanks. I searched, but missed this.

This topic was automatically closed 365 days after the last reply. New replies are no longer allowed.