Keo
April 10, 2018, 5:07pm
1
Hi all,
I am attempting to port the EZMultiPli to hubitat.
I am sure there is something else that needs to change in the driver, but I can't figure out what. Right now all it updates with motion active, but never switches to inactive.
// Express Controls EZMultiPli Multi-sensor
// Motion Sensor - Temperature - Light level - 8 Color Indicator LED - Z-Wave Range Extender - Wall Powered
// driver for SmartThings
// The EZMultiPli is also known as the HSM200 from HomeSeer.com
//
// 2017-04-10 - DrZwave (with help from Don Kirker) - changed fingerprint to the new format, lowered the OnTime
// and other parameters to be "more in line with ST user expectations", get the luminance in LUX so it reports in lux all the time.
// 2016-10-06 - erocm1231 - Added "updated" method to run when configuration options are changed. Depending on model of unit, luminance is being
// reported as a relative percentace or as a lux value. Added the option to configure this in the handler.
// 2016-01-28 - erocm1231 - Changed the configuration method to use scaledConfiguration so that it properly formatted negative numbers.
// Also, added configurationGet and a configurationReport method so that config values can be verified.
// 2015-12-04 - erocm1231 - added range value to preferences as suggested by @Dela-Rick.
// 2015-11-26 - erocm1231 - Fixed null condition error when adding as a new device.
// 2015-11-24 - erocm1231 - Added refresh command. Made a few changes to how the handler maps colors to the LEDs. Fixed
// the device not having its on/off status updated when colors are changed.
// 2015-11-23 - erocm1231 - Changed the look to match SmartThings v2 devices.
// 2015-11-21 - erocm1231 - Made code much more efficient. Also made it compatible when setColor is passed a hex value.
// Mapping of special colors: Soft White - Default - Yellow, White - Concentrate - White,
// Daylight - Energize - Teal, Warm White - Relax - Yellow
// 2015-11-19 - erocm1231 - Fixed a couple incorrect colors, changed setColor to be more compatible with other apps
show original
Any advice on what else I would need to change?
Keo
April 10, 2018, 8:50pm
2
Never mind. I just saw there is a preference to set the time out value. Default is 10 minutes.
Keo
April 14, 2018, 6:45pm
3
I’ve tried to get it working, but the device configuration never seem to set. I can change the interval to 1 minute but it still uses the default of 10 min. I’ve also not been able to figure out how to control the color. Can anyone help me out?
system
September 24, 2022, 11:05am
4
This topic was automatically closed 365 days after the last reply. New replies are no longer allowed.
