Ewelink bsd17 detected wrongly

petteri.joutseno · February 15, 2025, 3:11pm

Weird finger print because it is the same as E27 zigbee adapters I just installed before.
infofingerprint profileId:"0104", endpointId:"01", inClusters:"0000,0003,0004,0005,0006,1000,FC57,FC11", outClusters:"0019", model:"SWITCH-ZR03-1", manufacturer:"eWeLink", controllerType: "ZGB"

I tried generic zigbee swich, but that does not work.

Any idea for driver for this?

bertabcd1234 · February 15, 2025, 5:53pm

Did you run the "Configure" command after switching drivers? Try it first if not.

petteri.joutseno · February 16, 2025, 5:46am

Did not work yesterday. Now configure brought one State: Switch Off. Never seen that clean State list. Lets hope I can now forget that device.

system · February 16, 2026, 5:46am

This topic was automatically closed 365 days after the last reply. New replies are no longer allowed.