Everspring Utilitech (Lowes) Leak Sensor

[user2311]

I see someone posted a driver for these devices! Thanks. But… I cannot seem complete pairing w Hub. Worked fine with SmartThings Hub I’m trying to migrate away from. Any tips?

[kahn-hubitat]

i paired mine near hub and moved to basement.. you are hitting switch while pairing right. and also first do exclude

[kahn-hubitat]

i am just using generic zwave water sensor once paired.

[user2311]

Right. But I cannot complete pairing…

[user2311]

Yep. Did exclude. Will try near hub.

[user2311]

Works now. Excluded. Reset. Included while close to hub! Thx !

[jlv]

They are Z-wave, not Z-wave Plus, so they need to be paired next to the hub as they don't support NWI (network wide include).

I still have one of these new-in-box!

[rlithgow1]

Have a gander at this before continuing. Pay close attention to the z-wave section and the part about ghosts

Are you new to home automation or Hubitat or coming from a different platform such as SmartThings, Vera, or Wink? This may help!

Just throwing this out there. It may or may not be a help and I'm sure many others will contribute to this thread. Here are a few things to start you off. Z-wave Devices: 1: You do not need Wink/ST/Vera etc. to exclude your existing z-wave devices. Hubitat can do the exclusion for you. (Make sure you turn off your old hub first!) In most cases this is sufficient before pairing. Sometimes though you may need to factory reset the device. Non Plus z-wave devices may have to be included/excluded …